OME CATALOGUE 54 AUGUST 2023 (Nr. 54)

DEFENDER & COUNTY 110 LONG TRAVEL FRONT SELECTION - Estimated Lift 50mm Part Number Qty Notes Spring 3062 1 1,2 Shock - N/Sport 60018 Shock - N/Plus 63018 Spring 3063 1 1,2 Shock - N/Sport *60070 / 60018 Shock - N/Plus *63070 / 63018 FIT KITS & HARDWARE Loc Part Number Qty Note F OMESD32 CALR1 CALR2 F OMELRCP1 EA 4 F/R FK62 F/R FK63 REAR SELECTION Part Number Qty Note Spring 3064 1 1,2,5 Shock - N/Sport 60018 Shock - N/Plus 63018 Spring 3065 1 1,2 Shock - N/Sport *60070 / 60018 Shock - N/Plus *63070 / 63018 Spring 3066 1 1,2 Shock - N/Sport 60070 Shock - N/Plus 63070 FIT KITS & HARDWARE Loc Part Number Qty Note R OMELRCP3 EA 4 R FK64 R OMESB0068 R OMESB0069 F/R FK62 F/R FK63 GLOBAL 2 Description STEERING DAMPER 2 F CASTER KIT 3 COIL PACKER LAND ROVER No Bar Bar/ Winch/ Accessories DIESEL ENGINE 2 BUMP SPACER KIT 2 SWAY BAR SPACER KIT 1 COIL PACKER BUSH KIT T/ARM OFFSET 16MM BUSH KIT T/ARM OFFSET 20MM BUMP SPACER KIT SWAY BAR SPACER KIT REAR UPPER SHOCK MOUNT 1 6 2 ALL MODELS Estimated Lift 50mm Medium Load Constant 300kg Constant 500kg Description 2 2 2 2 2 2 2 1 Comments Caution: Front driveshaft MUST be replaced / modified with Double Cardan Joints and checked for Uni bind with OME shocks installed at droop. FK62, FK63, FK64 are mandatory fitment also. 1 When fitting coil springs recommended, it is mandatory to use 60018/60070 shock absorbers to achieve minimum down travel requirement. 2 When fitting 60018 / 60070 the following are mandatory requirements: * Fit longer coils 3062-3066 for springs to remain trapped with shocks fully extended * Fit FK62 to prevent shock damage * Fit FK63 for front driveshaft clearance and rear extended travel * Fit FK64 which replaces OE upper shock mount when fitting rear shocks * Remove any inner helper coils already fitted 3 Caster Kit will increase caster angle by 2 degrees. Check manufacturer's specifications to determine if Caster Kit is required. CALR1 suits 38mm wide control arms. CALR2 suits 44mm wide control arms. 4 8mm Steel Coil Seat Packer, refer to selection chart supplied with packer. Important: To prevent possible over stressing of the spring, only one packer can be fitted under each coil seat. 5 Important: 3064 has reduced spring rate from OE to provide improved ride quality for light loads. OE springs are designated as medium load springs. 6 Trailing Arm Bush is an optional fit. Bush kit is offset and accommodates for the increased angle of the trailing arm due to longer travel. Page 126