OME International Catalogue

DEFENDER & COUNTY 110 LONG TRAVEL FRONT SELECTION - Estimated Lift 50mm Part Number Qty Unit Price Notes Spring 3062 1 1,2 Shock - N/Sport 60018 2 2 Spring 3063 1 1,2 Shock - N/Sport *60070 / 60018 2 2 FIT KITS & HARDWARE Loc Part Number Qty Unit Price Note F OMESD32 CALR1 CALR2 F OMELRCP1 EA 4 F/R FK62 F/R FK63 REAR SELECTION Part Number Qty Unit Price Note Spring 3064 1 1,2,5 Shock - N/Sport 60018 2 2 Spring 3065 1 1,2 Shock - N/Sport *60070 / 60018 2 2 Spring 3066 1 1,2 Shock - N/Sport 60070 2 2 FIT KITS & HARDWARE Loc Part Number Qty Unit Price Note R OMELRCP3 EA 4 R FK64 R OMESB0068 R OMESB0069 F/R FK62 F/R FK63 BUMP SPACER KIT 2 SWAY BAR SPACER KIT 1 COIL PACKER BUSH KIT T/ARM OFFSET 16MM BUSH KIT T/ARM OFFSET 20MM BUMP SPACER KIT SWAY BAR SPACER KIT REAR UPPER SHOCK MOUNT 1 6 2 ALL MODELS Est Lift 50mm Medium Load Constant 300kg Constant 500kg LAND ROVER No Bar Bar/ Winch/ Accessories 1 F CASTER KIT 3 COIL PACKER DIESEL ENGINE Description Description STEERING DAMPER GLOBAL Comments Caution: Front driveshaft MUST be replaced / modified with Double Cardan Joints and checked for Uni bind with OME shocks installed at droop. FK62, FK63, FK64 are mandatory fitment also. 1 When fitting coil springs recommended, it is mandatory to use 60018/60070 shock absorbers to achieve minimum down travel requirement. 2 When fitting 60018 / 60070 the following are mandatory requirements: * Fit longer coils 3062-3066 for springs to remain trapped with shocks fully extended * Fit FK62 to prevent shock damage * Fit FK63 for front driveshaft clearance and rear extended travel * Fit FK64 which replaces OE upper shock mount when fitting rear shocks * Remove any inner helper coils already fitted 3 Caster Kit will increase caster angle by 2 degrees. Check manufacturer's specifications to determine if Caster Kit is required. CALR1 suits 38mm wide control arms. CALR2 suits 44mm wide control arms. 4 8mm Steel Coil Seat Packer, refer to selection chart supplied with packer. Important: To prevent possible over stressing of the spring, only one packer can be fitted under each coil seat. 5 Important: 3064 has reduced spring rate from OE to provide improved ride quality for light loads. OE springs are designated as medium load springs. 6 Trailing Arm Bush is an optional fit. Bush kit is offset and accommodates for the increased angle of the trailing arm due to longer travel. 100 OME INT CAT. NO.50 OCTOBER 2022