OME CATALOGUE 54 AUGUST 2023 (Nr. 54)

PRADO 150 WAGON SERIES TO 09/17 (EXCLUDES KAKADU MODEL) FRONT SELECTION Part Number Qty Note Spring 2869 1 1,3 Strut - N/Sport 90010 2 2,6 Spring 2884 1 1,3 Strut - N/Sport 90010 2 2,6 Spring 2885 1 1,3 Strut - N/Sport 90010 2 2,6 Spring 4005 1 1,3 Strut - N/Plus 93010 2 2,6,7 Spring 4005 1 1,3 Strut MT64901007 2 2,6,7 Strut - LH BP5190002L Strut - RH BP5190002R Fit Kit VM80010008 1 Strut - LH BP5190004L Strut - RH BP5190002R Fit Kit VM80010009 1 FRONT SELECTION Part Number Qty Note Spring 2883 1 1,3,4 Strut - N/Sport 90010 2 2,6 Spring 2883 1 1,3,4 Strut - N/Sport 90010 2 2,6 Spring 2869 1 1,3 Strut - N/Sport 90010 2 2,6 Spring 4001 1 1,3 Strut - N/Plus 93010 2 2,6,7 Spring 4001 1 1,3 Strut MT64901007 2 2,6,7 Strut - LH BP5190002L Strut - RH BP5190002R Fit Kit VM80010008 1 Strut - LH BP5190004L Strut - RH BP5190002R Fit Kit VM80010009 1 FIT KITS & HARDWARE Loc Part Number Qty Note F UCA0004 1 5 F OME95PF5 EA 1 F UPPER STRUT BUSHES OME3133 2 F OMETH002 6 Part # Qty Note UCASP010 1 UCASP002 EA UCASP011 1 OME UCA Boot 2pk Estimated Lift 30mm 2 Bar/ Winch/ Accessories Nitro + OME UCA Ball Joint 1pk No Bar Bar Only BP-51 SUITS KDSS OME UCA Eye Bush 2pk 1+1 1+1 TOYOTA DOMESTIC (AUS) Description Bar Only V6 4.0L PETROL ENGINE UPPER CONTROL ARM No Bar V6 4.0L PETROL ENGINE Estimated Lift 50mm TRIM PACKER BP-51 NO KDSS BP-51 SUITS KDSS 1+1 Description STRUT TOP HAT KIT 1+1 MT64 MT64 BP-51 NO KDSS SERVICE PARTS Nitro + Bar/ Winch/ Accessories Comments 1 Vehicles with KDSS, must have 1 x OME95PF5 packer installed on the front right hand side to maintain correct trim. For Plus & MT-64 use included packers/ snap rings. 2 No top mounting bushes supplied use OME3133. OE bushes may be re-used if on good condition. 3 For fitment to Models with Toyota's KDSS (Kinetic Dynamic Suspension System) fitted excluding Kakadu Models, please refer to OME's Fitting Hints & Tips (OME Bulletin 70 LC200 KDSS Fitting Hints). 4 When 2883 is fitted to Petrol Model, ride height increase will be approximately 40mm. 5 The OME Upper Control Arm will provide an increase between +2.5 and +3.5 degrees of caster and up to 1.5 degrees of negative camber increase (figures based off an approximate 50mm lift). Please note after fitment of Upper Control Arm a vehicle wheel alignment will be required. 6 Strut Top Hat Kit may be required if original equipment is worn. 7 Does not suit OE coil. Page 220