OME CATALOGUE 54 AUGUST 2023 (Nr. 54)

2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. FK22 Front Shock Absorber Upper Mount Support Bracket Kit is a mandatory fitment. Shock lower body stone guards are recommended fitment to rear shocks to protect against severe stone peppering encountered on loose road surfaces. OME661 (suits Sorento BL To 09, FJ Criser 06 On, 4 Runner 10 On, LandCruiser 76 LWB, 200 Series, Prado 150 09 on coil sprung not Kakadu, 120 Series 10/02 to 09 not TEMS & Prado 90 Series to 10/2002 LWB). OME662 (suits LandCruiser 105 & 80 Series with 34mm diameter Control Arm, 100 Series IFS not AHC with 40mm diameter Control Arm). OME660 (all other models). shock absorber. prevent damage to sway bar due to increased wheel droop. Rear shock has 50mm longer travel than original equipment. 1975 and newer FJ40's may need to use N76 shocks in rear: Pre 1975 shock eye in the top of the axle housing use N89 18 / 60032 18 / 60064 18 . Post 1975 lower shock eye is below leaf spring use N76 with OMEB11 Bush Kit. Replacement dust boot part numbers Nitrocharger: OME512422 - Large To obtain maximum ride quality improvement it is recommended that an OME replacement stabiliser bar (OMESTAB1) be fitted. OMESD35 18 will suit D21 models only. Only suitable for models equipped with original steering damper. Shocks are the same length as OE. OME030 18 is shorter than OME029 and must be used with OE coils to ensure coils remain entrapped. No top mounting bushes supplied, re-use OE bushes. FK28 18 Bump Stop Spacer Kit is a mandatory fitment with N103S Struts. When remaining stock is exhausted no further product will be available. No top mounting bushes supplied, refer to vehicle specific application to select relevant upper strut bushes. OE bushes may be Note: Replacement dust boot part numbers Nitrocharger: OME412422 - Small FK22 support brackets must be installed to upper shock mounting brackets on late 1996 on models manufactured in Thailand. N208S 18 can only be installed with OME Coil Springs. No top mounting bushes supplied, re-use OE bushes. N179 suits models with single rear shock set up. Models with twin rear shocks require N179 fitment rear of axle, N180 front of axle, also fitment of OME660 stone shields are recommended on the N180. OMESD40 will only fit left hand drive models. It may be necessary to slightly increase the clearance in the front wishbone to allow the shock absorber to fit. Do not modify the FK18 rear sway bar extension bracket for LWB models and FK24 for SWB models are mandatory fitment with Nitrochargers to re-used if in good condition. FK42 is a mandatory fitment to space sway bar link away from shock absorber. Vehicles with ABS will require ABS Bracket Kit SMP638. Front strut has 40mm longer travel than original equipment. NITROCHARGERS & STEERING STABILISERS NOTES - (continued): *first part number has firmer valving. Page 15