OME International Catalogue

DMAX 2008 TO 2011 ALL MODELS COLORADO RC 2008 TO 2011 ALL MODELS RODEO RA 2003 TO 2011 ALL MODELS (NOT USA) FRONT SELECTION Part Number Qty Unit Price Notes Torsion Bars 303012 1 1 Strut - N/Sport 60031 REAR SELECTION - Estimated Lift 30-50mm Part Number Qty Unit Price Note Leaf Spring CS062R 1 2 Shock - N/Charger N89 Shock - N/Sport 60032 Leaf Spring CS063R 1 2 Shock - N/Sport *60064 / 60032 OMESB80 2 OMEU66 4 OMEGS13 OMEGP11 FIT KITS & HARDWARE Loc Part Number Qty Unit Price Note R FK26 1 3 R UCB15 R 4 RODEO/DMAX TO 2003 ALL MODELS (NOT USA) FRONT SELECTION Part Number Qty Unit Price Notes Torsion Bars 303004 1 1 Strut - N/Sport 60031 REAR SELECTION Part Number Qty Unit Price Note Leaf Spring CS028R 3,4 Shock - N/Sport 60032 Leaf Spring CS029R 3,4 Shock - N/Sport 60064 OMESB80 2 OMEU59A 4 2 OMEGS13 3 OMEGP11 FIT KITS & HARDWARE Loc Part Number Qty Unit Price Note R FK14 1 3 R UCB16 R 5 HOLDEN / ISUZU / GM SPRING BUSH KIT U BOLTS GREASABLE SHACKLE KIT GREASABLE FIXED END PIN KIT Medium Load Constant 300kg Estimated Lift 30-50mm 1 PETROL & DIESEL ENGINES No Bar/ No Load 2 EXTRA LEAF 2 2 EXTRA LEAF CENTRE BOLT ALL MODELS Description ANTI INVERSION KIT CENTRE BOLT ANTI INVERSION KIT GREASABLE SHACKLE KIT DOMESTIC (AUS) DOMESTIC (AUS) GREASABLE FIXED END PIN KIT Est Lift 30-50mm Description SPRING BUSH KIT U BOLTS 2 2 PETROL AND DIESEL ENGINES 1 Bar/ Winch/ Accessories 2 ALL MODELS Medium Load Constant 400kg 2 2 Comments 1 Raise or lower front end clearance and trim vehicle by adjusting front torsion bars. Important: A minimum of 60mm of droop must be maintained. It has been found, due to vehicle manufacturing tolerances, that in some cases front shock absorbers may contact the steering arm when on full lock. Fitter should check for this and where required a small indentation should be made to the body of the shock absorber. 303012 torsion bars have a lighter rate than OE and improve ride comfort for vehicles with no front accessory weight. Due to their heavy rate, the OE torsion bars are suitable for vehicles with front accessory weight. 2 Include tray weight in constant load calculation. CS062R and CS063R can be installed to high height 4x2 Models. OME leaf does not fit low height 4x2 Models. 3 FK26 only needed if not fitting Greasable Shackle Kit. 4 Refer to Leaf Spring Service Parts section for Centre Bolt selection. Comments 1 Raise or lower front end clearance and trim vehicle by adjusting front torsion bars. Important : A minimum of 60mm of droop must be maintained. 2 Vehicles with four leaf OE spring stack require U bolts OMEU59A. 3 FK14 must be fitted if OMEGS13 greasable shackles are not fitted. 4 Include tray weight in constant load calculation. 5 Refer to Leaf Spring Service Parts section for Centre Bolt selection. 91 OME INT CAT NO.50 OCTOBER 2022