ARB OME application catalogue

Contents!A1 Contents!A1 QTY UNIT PRICE $ 1 2 1 2 1 QTY UNIT PRICE $ 1 2 1 2 1 2 1 REMARKS: PART NUMBER When fitting coil springs recommended, it is mandatory to use BP-51 shock absorbers to achieve minimum down travel requirement. * Fit longer coils 3062-3066 for springs to remain trapped with shocks fully extended * Remove any inner helper coils already fitted When fitting BP-51 shock absorbers the following are mandatory requirements: Caster Kit will increase caster angle by 2 o . Check manufacturer's specifications to determine if Caster Kit is required. CALR1 suits 38mm wide control arms. CALR2 suits 44mm wide control arms. 8mm Steel Coil Seat Packer, refer to selection chart supplied with packer. Important: To prevent possible over stressing of the spring, only one packer can be fitted under each coil seat. BP-51 KIT DEFENDER REAR STEERING DAMPER CASTER KIT COIL PACKER OMELRCP1 1 3066 CALR1 CALR2 DEFENDER 110 BP-51 LONG TRAVEL (EXCLUDES PUMA MODELS) VM80010037 BP-51 FRONT SHOCK BP-51 REAR SHOCK BP5160036 SPRING: MEDIUM LOAD 3064 BP-51 REAR SHOCK BP5160036 SPRING: CONSTANT 300 KGS 3065 BP-51 REAR SHOCK BP5160036 SPRING: CONSTANT 500 KGS Caution: Front driveshaft MUST be replaced / modified with Double Important: 3064 has reduced spring rate from OE to provide improved ride Cardan Joints and checked for Uni bind with BP-51 shocks installed at droop. quality for light loads. REAR DEFENDER 110 SPRING: BAR / BAR & WINCH 3063 BP-51 FRONT SHOCK BP5160045 BP-51 KIT DEFENDER FRONT VM80010036 OMESD32 LAND ROVER the increased angle of the trailing arm due to longer travel. BUSH KIT TRAILING ARM OFFSET 16MM PIN (OPTIONAL) OMESB0068 BUSH KIT TRAILING ARM OFFSET 20MM PIN (OPTIONAL) OMESB0069 Trailing Arm Bush is an optional fit. Bush kit is offset and accommodates for COIL PACKER OMELRCP3 BP5160035 Estimated Lift: To 50mm FRONT 2.5L DIESEL ENGINES Estimated Lift: To 50mm PART NUMBER SPRING: NO BAR 3062 4 3 1 1 2 2 1 4 5 2 1 2 2 1 1 2 3 4 5 6 6 Page 67 OME INT CAT. NO.47 DECEMBER 2021