ARB OME application catalogue

Contents!A1 Note: Replacement dust boot part numbers LTR: OME512422 - Large Black Replacement dust boot part numbers LTR: OME412422 - Small Yellow On Road/Off Road 40-80psi (2.8 - 5.5 BAR) Competition 80-100psi (5.5 - 6.9 BAR) An increase in gas pressure firms up ride quality but will not alter ride height. Note: This can be done for you by your Old Man Emu Stockist. is reached. When using a Schrader valve to gas your LTR Shock absorber first set the of the remote canister. Gas the canister until the shock absorber shaft is fully extended, hold gas pressure for 30 seconds, release Schrader valve and remove. pressure gauge to the required pressure. Attach the Schrader valve to the air fitting at the end body and canister for any mud and debris build up and clean if necessary. The following checks need to be carried out as part of regular vehicle maintenance. If the boot is found to be detached thoroughly clean the shock absorber shaft and inside To ensure maximum shock absorber performance check gas pressure every 20,000km. Ensure all polyurethane bushes, locating washers and nuts are in good condition and securely fastened. Check that the polyurethane boot is securely fastened in place and that it is not damaged. Important: Gassing of your LTR shock absorber should be carried out before fitment to the vehicle. If LTRs are already fitted the vehicle's suspension should be at full extension before gassing. the boot before reattaching it. LTR REMOTE CANISTERS The only recommended gas to use in LTR shock absorbers is Nitrogen. A Schrader valve, To ensure maximum cooling of your LTR shock absorber inspect the shock absorber GASSING REMOTE CANISTER SHOCK ABSORBERS MINIMUM/MAXIMUM GAS PRESSURE MAINTENANCE part number 2755, from Schrader Automotive Inc is required to guarantee correct pressure Page 20 OME INT CAT. NO.43 APRIL 2020